Vinyl Instructions
Please follow the instructions below for best results :
- Receive transfers in the post & read this sheet before starting!
- Preheat iron for 3 minutes on the hottest cotton setting (NO STEAM!)
- Choose a hard surface at waist level i.e. kitchen worktop or desk (NOT AN IRONING BOARD)
- Lay your garment on the hard surface and iron over it to remove creases
- Place transfer face down in position on garment and cover with silicon paper
- Iron over all areas of the vinyl print with firm downward pressure.
- Move the iron up and down, left to right, to ensure all areas have been firmly pressed with the iron – SEE BACK OF THIS SHEET FOR TIMINGS!
- Peel the backing away from one corner to check it is stuck… if it is stuck then slowly peel away the backing completely leaving the print on your garment.
- Once applied, cover the print again with the silicon paper and re-iron for 10-20 seconds to fix it in place (do not let the iron touch the print directly).
Timing Instructions:
IRON WITH FIRM PRESSURE OVER ALL AREAS OF THE PRINT FOR APPROX
10-30 SECONDS
(PEEL BACK FROM ONE CORNER TO CHECK IT IS STUCK PROPERLY)
ONCE STUCK TO YOUR GARMENT –
COVER THE PRINT WITH THE HEAT PROOF PAPER AND RE-IRON FOR ANOTHER 10-20 SECONDS TO FIX IN PLACE.
NOTE – ACTUAL TIME TAKEN MAY VARY DEPENDING ON PRINT SIZE, USER, TEMPERATURE / QUALITY OF IRON ETC.
Wash & Care Instructions:
- Leave transfer for 24 hours before washing.
- DO NOT – Dry clean
- DO NOT – Directly iron transfer
- DO NOT – Bleach
- DO NOT – Tumble dry